Showing posts with label Incense container. Show all posts
Showing posts with label Incense container. Show all posts

Friday, May 24, 2024

249. WAKAO Toshisada, 1933- , Shino-ware incense container

249.  WAKAO Toshisada  若尾利貞,  1933- , Shino kōgō 志野香合 (Shino-ware incense container)










For Wakao, see item 248. 

Light tan clay, Shino glaze, with some white areas, but mostly a light brownish red, with decoration in a dark brown glaze; the shelf on the lower part, the outer side of the flange, and the interior of the upper part that rests on the shelf and abuts the flange were left unglazed. Weight: 80 g (2.3 oz). Height: 5.1 cm (2 in). Width: 5.1 cm (2 in). 

The overall shape resembles an upside-down acorn without the cap. This sits on a foot ring 3.8 cm (1-1/2 in) in diameter; the inside of the ring has been hollowed out to a depth of 0.3 cm (1/8 in). The ring has no exterior wall. Instead the outside walls of the piece rise in a continuous convex arc to the top. The walls of the lower part end 1.75 cm (5/8 in) above the base. At this point there is a horizontal shelf 0.5 cm (3/16 in) wide, with a vertical flange rising 0.75 cm (1/4 in) above the shelf. The upper part is ringed with horizontal grooves, perhaps remnants of clay coils. The upper part ends in a blunted peak at the center top. The piece is pitted and bumpy from the Shino glaze. 

This has a Shino glaze, mostly colored a light brownish red, but with some areas of white. Wakao used a brown glaze to decorate the outside in four places with grass-like designs. These continue across the divide between the upper and lower parts. 

This came with a wooden box, inscribed by Wakao in two lines: 志野   香合 /  利貞 Shino kōgō / Toshisada (Shino-ware incense container / Toshisada) , with the artist’s seal stamped in red. Included in the box were a short biography and two wrapping cloths. 

Purchased from Dai Ichi Arts, New York City, May 2024 (invoice, shipping label, card from owner).

Tuesday, May 21, 2024

248. WAKAO Toshisada, 1933- , Oribe-ware incense container

248. WAKAO Toshisada 若尾利貞, 1933- , Oribe kōgō 織部香合 (Oribe-ware incense box)
 









Wakao was born in Tajimi. After graduating from junior high school, he worked at a ceramics factory while studying Shino-ware on his own. He went independent in 1970. He is a recipient of the Katō Kōbei Award, the Mino Newcomer’s Award, and the New Craft Award, among other honors. He has been a participant and award-winner at the Chūbu Art Exhibition, Gifu Prefectural General Design Exhibition, Asahi Ceramics Exhibition, Japanese Traditional Crafts Exhibition, and the Chūnichi International Ceramics Exhibition. He has had solo exhibitions held at the Nihonbashi Takashimaya, Nagoya Matsuzakaya, and Tokyo Tsubogen, among other venues. He is a member of the Japan Kōgei Association.

Cream-colored clay, with Oribe green, brown, and cream glazes; the edges where the two halves meet are unglazed. Weight: 102 g (3.6 oz). Height: overall, 4.3 cm (1-3/4 in). Width: 6 cm (2-3/8 in).                

Bottom part: This sits on a foot ring 3.7 cm (1-1/2 in) in diameter and about 0.3 cm (1/8 in) high on both sides. Within the ring is the artist’s sigil written with a brush in brown glaze. Above the foot ring, the walls flare outward at about a 45-degree angle to meet the sides 0.5 cm (3/16 in) above the base. The walls rise in more or less a straight line to the top of the bottom part 1.8 cm (3/4 in) above the base; at this point the piece has a diameter of 3.2 cm (1-1/4 in). There is a horizontal shelf about 0.5 cm (3/16 in) wide on which the top part rests. At the inside edge of this shelf is a vertical flange 0.8 cm (5/16 in) high. The interior of this part mirrors the shape of the exterior walls. 

Top part. Overall, this part is 3.2 cm (1-1/8 in) high. The bottom edge is flush with the top edge of the bottom part; The walls are 0.5 cm (3/16 in) thick. Above this, the walls curve inward in a high convex arc to a flat circular area at the top 3.4 cm (1-1/4 in) in diameter. In the center of this is a roughly circular small button less than a centimeter (3/8 in) in diameter. The interior of this part mirrors the shape of the exterior. 

There are eight vertical grooves extending from the circle at the top of the upper part across the body of the piece to the lower edge of the walls. The texture of the exterior is bumpy; the interior is smooth. 

The circle at the top and the upper half of the top part were covered with the green Oribe glaze. Below this each groove was filled in with the brown Oribe glaze; between each of these lines Wakao used the brown glaze to draw an irregular vertical shape. Wakao also used this glaze to draw his sigil on the base. Other than the edges where the halves meet, the rest of the piece has a cream glaze. 

This came in a small wooden box inscribed by the artist in two lines: 織部香合 / 利貞 Oribe kōgō / Toshisada (Oribe incense container / Toshisada), followed by the artist’s seal stamped in red. Included in the box were a blue wrapping cloth, also stamped with the artist’s seal in red, and a short biography.

Purchased from Dai Ichi Arts in New York City in May 2024. (invoice, shipping label)

Thursday, February 2, 2023

203. Ko-Oribe kōgō (incense container)

203. Ko-Oribe kōgō  香合 (incense container for Japanese tea ceremony)










Brown clay. Glazed in Oribe green, cream, and brown; base and neighboring portions of wall and the edges where the top and bottom halves meet were left unglazed.  Weight: (entire) 94 g (3.4 oz); (lid) 46 g; (bottom) 48 g. Height: (entire) 4.4 cm (1-3/4 in); (lid) 2.8 cm (1-1/8 in); (bottom) 2.3 cm (7/8 in). Width: 5.5 cm (2-3/16 in).

This sits on a round base 2.5 cm (1 in) in diameter. There is no foot ring per se, but the inside of the base has been hollowed out to a shallow depth.  Above the base the walls rise at about a 30-degree angle to the full width about 0.6 cm (1/4 in) above the base. From there the walls rise in more or less a straight line to a height of 3.2 cm (1-1/4 in). They then curve inward toward the center to a height of 3.8 cm (1-1/2 in). A topknot of a coiled, ribbed cordlike string of clay sits in the center of the lid. It’s too small to serve as a knob to lift the lid. The sides of the box form a square with rounded corners (or alternatively, a circle has been squared off to make straight sides.  Both the lid and the bottom have a horizontal groove running around the circumference, roughly in the middle of each part. The upper surface of the lid has another groove about 0.6 cm (1/4 in) in from the sides to make a slightly raised portion. The walls are about 0.3 (1/8 in) thick. The interior of the box mirrors the exterior. The bottom has a flange on the inner side of the top edge that fits snugly inside the lid. The surface is bumpy.

The topknot was glazed in Oribe green. The exterior and interior walls (with the exceptions noted above) were glazed in cream. On the front of the box is a vaguely plant-like design in brown. The cream glaze on the exterior has darkened due to aging.

The seller dated this to the seventeenth/eighteenth centuries and labeled it as Shino ware. The box this came in has no inscription.

Purchased from Treasures of Old Times in Bangkok, November 2022.

Monday, May 3, 2021

15. Oribe rectangular incense container (kōgō)

15. Oribe rectangular incense container (kōgō) 






Coarse, light-gray clay, glazed in gray, brown, and green; bottom of container and the interior rims of the two parts left unglazed. Weight: 90 g (3 oz). Dimensions: 5.4 x 4.4 cm (2-1/8 x 1-3/4 in). Height: overall, 2.5 cm (15/16 in); top, 1.3 cm (1/2 in), bottom, 1.2 cm (7/16 in).

A rectangular area in the center of the base was carved away, to make a shallow depression. Semi-circular grooves were cut into the base of the container (2), the interior surface of the lid (3), and the bottom of the interior well (2). A raised rim was added around the well of the bottom part; it fits snugly into the part hollowed out on the underside of the lid.

One corner of the lid was dipped in green glaze. Decoration was applied using a brush and brown glaze to the top and sides. The interior well in the bottom section, the interior surface of the underside of the lid where it does not come into contact with the bottom part, and the two grooves on the bottom are covered with a transparent glaze. The surfaces where the two parts meet and most of the bottom were left unglazed. A raised rim was added around the well of the bottom part; it fits snugly into the part hollowed out on the underside of the lid.

Incense containers (Japanese: 香合 kōgō) are used to hold small pellets of rolled incense.

Purchased at the Japan Trade Center in San Francisco in the late 1980s or early 1990s.

 

14. Oribe fan-shaped incense container (kōgō)

14. Oribe fan-shaped incense container (kōgō) 


 




White clay, glazed in cream, green, and brown; bottom of container and the interior rims left unglazed. Weight: 58 g (2 oz). Top dimensions: from apex to center of arc (radius), 5 cm (2 in); widest distance across arc, 6.6 cm (2-5/8 in).  Height: overall, 3 cm (1-1/8 in); top, 1.7 cm (5/8 in); bottom, 1.3 cm (1/2 in).

Six triangular shapes have been scored into the clay at the apex to represent the ribs of the fan (visible in the photo). The upper left-hand corner of the fan has been dipped in green glaze; the green glaze was applied separately to the top and bottom parts of the container (see the second photo). At four different places on the container, five plum blossoms, three on the lid and two on the sides of the bottom piece, were drawn in brown glaze (probably an iron-rich slip) using a brush. The interiors of the two parts of the container were glazed, but the surfaces where the two parts meet were left unglazed, as was the bottom of the container. The bottom has three parallel grooves made with the edge of a spatula (see the last photo). The two parts fit together loosely.

This is modern piece, probably made in the early 1990s. Incense containers (Japanese: 香合 kōgō) are used to hold small pellets of rolled incense.

This was purchased in Japan and given to me in 1993.  

Pottery

Looking for suggestions

I need to dispose of my collection. I've tried to donate it to several local museums or schools with ceramics programs, but no one wants...